Dust Treatment Scheme after Cutting of Milling Cutter PCBA Plate Divider

March 22, 2021

It is believed that after all the process of PCBA board is completed, when the last slitting is carried out, there will be a problem that bothers you, that is, how to clean the dust after the PCBA board is sliced? Can the dust be treated cleanly without washing the board, without affecting the normal use of the partitioned PCBA board?

 

In view of the above problems, Seprays has put forward a suction scheme for dust removal of milling cutter PCBA splitter. A suction machine can be provided for milling cutter splitter. The dust produced by milling cutter splitter can be sucked away immediately by the suction machine without residual dust.

 

If there is still a lot of dust in the use of PCBA board, it may be that the following aspects are not well done.

 

1 Dust causes:

A Customer uses the tool of milling cutter splitter as the base, the height of the tool is not enough, and the brush does not touch the cover plate, which leads to the failure of dust cleaning.

 

B Vacuum cleaner has not been cleaned up for a long time (many customers feedback once every two months). It is suggested that the vacuum cleaner should be cleaned regularly, not for a long time.

 

Customer C purchased the PCBA splitter equipment of Seprays Milling Tool, but the filter bag was purchased at will outside. The filter bag was thicker than Seprays's filter bag, and the wind power was reduced when it was vacuum cleaned. It is necessary to replace the filter bag with Seprays brand. If it is another brand of milling cutter splitter, it should also be matched with the use of brand filter bags, so that dust can be thoroughly cleaned up.

 

Our Website: www.seprays.com

Get in touch with us
Contact Person : Ms. Violet
Tel : +86-13929264317
Fax : 86-0769-82855028
Characters Remaining(20/3000)